Laser Cutter Training - June/July 2025

The next Training Course for the Laser Cutter is coming up.

The first training session will be held on Wednesday 25th June 2025 at 9am. The training will continue each week on Wedensday mornings, until all attendees are proficient enough in using the laser cutter safely and can produce some simple projects in Lightburn. In the past, members required 5-7 sessions, but it really depends on your computer literacy and willingness to learn.

I would like to keep the sessions fairly fluid, where we work together on a few simple projects. Obviously I will explain the general setup of the Laser Cutter, including the all important safety procedures. We also will go through all necessary steps to run Lightburn, the software the shed uses for the laser.

Once the training course is booked, I will send out some information to all attending members, including access to a members version of Lightburn (reduced cost).

This is a free training course but it is a ticketed event (only 6 spots available), so get your ticket now.

Cheers
Otti